Final draft ETSI EN 301 893 V1.8.0 (2015-01)
5 GHz high performance RLAN;
Harmonized EN covering the essential requirements
of article 3.2 of the R&TTE Directive
Reference
REN/BRAN-0060011
Keywords
access, broadband, LAN, layer 1, radio,
regulation, testing
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88
Important notice
The present document can be downloaded from:
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2015.
All rights reserved.
DECT TM, PLUGTESTS TM, UMTS TM and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
3GPP TM and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
Contents
Intellectual Property Rights (7)
Foreword (7)
Modal verbs terminology (7)
Introduction (7)
1 Scope
(8)
(8)
2 References
(8)
references
2.1 Normative
微软中国区总裁
(9)
references
2.2 Informative
symbols and abbreviations (9)
3 Definitions,
3.1 Definitions
(9)
(12)
3.2 Symbols
(12)
3.3 Abbreviations
requirements specifications (13)
4 Technical
profile
(13)
4.1 Environmental
frequencies
(13)
4.2 Centre
(13)
4.2.1 General
(13)
4.2.2 Definition
4.2.3 Limits
(14)
4.2.4 Conformance (14)
4.3 Nominal Channel Bandwidth and Occupied Channel Bandwidth (14)
(14)
4.3.1 Definition
(14)
4.3.2 Limits
4.3.3 Conformance (14)
4.4 RF output power, Transmit Power Control (TPC) and power density (14)
(14)
4.4.1 Definitions
4.4.1.1 RF Output Power (14)
4.4.1.2 Transmit Power Control (TPC) (14)
(14)
4.4.1.3 Power
Density
(15)
4.4.2 Limits
4.4.2.1 General
(15)
4.4.2.2 Limits for RF output power and power density at the highest power level (15)
4.4.2.3 Limit for RF output power at the lowest power level of the TPC range (15)
4.4.3 Conformance (15)
4.5 Transmitter unwanted emissions (16)
4.5.1 Transmitter unwanted emissions outside the 5 GHz RLAN bands (16)
(16)
4.5.1.1 Definition
(16)
4.5.1.2 Limits
4.5.1.3 Conformance (16)
4.5.2 Transmitter unwanted emissions within the 5 GHz RLAN bands (16)
4.5.2.1 Definition
(16)
(17)
4.5.2.2 Limits
4.5.2.3 Conformance (17)
4.6 Receiver spurious emissions (17)
(17)
4.6.1 Definition
(17)
4.6.2 Limits
4.6.3 Conformance (18)
4.7 Dynamic Frequency Selection (DFS) (18)
4.7.1 Introduction (18)
(18)
4.7.1.1 General
4.7.1.2 Applicable frequency range (18)
modes
(18)
operational
4.7.1.3 DFS
(18)
operation
4.7.1.4 DFS
4.7.2 DFS technical requirements specifications (19)
4.7.2.1 Applicability (19)
(20)
4.7.2.2.2 Limit
4.7.2.2.3 Conformance (20)
4.7.2.3 Off-Channel CAC (Off-Channel Channel Availability Check) (20)
4.7.2.3.1 Definition (20)
(21)
4.7.2.3.2 Limit
4.7.2.3.3 Conformance (21)
(21)
4.7.2.4 In-Service
Monitoring
4.7.2.4.1 Definition (21)
4.7.2.4.2 Limit
(21)
4.7.2.4.3 Conformance (21)
Shutdown
(21)
4.7.2.5 Channel
4.7.2.5.1 Definition (21)
(21)
4.7.2.
5.2 Limit
4.7.2.5.3 Conformance (21)
(22)
Period
4.7.2.6 Non-Occupancy
4.7.2.6.1 Definition (22)
(22)
4.7.2.6.2 Limit
4.7.2.6.3 Conformance (22)
(22)
4.7.2.7 Uniform
Spreading
4.7.2.7.1 Definition (22)
(22)
4.7.2.7.2 Limit
4.8 Adaptivity (Channel Access Mechanism) (22)
4.8.1 Applicability
(22)
(23)
4.8.2 Definition
4.8.3 Requirements and limits (23)
4.8.3.1 Frame Based Equipment (23)
Based Equipment (24)
4.8.3.2 Load
4.8.3.3 Short Control Signalling Transmissions (26)
4.8.3.3.1 Definition (26)
(26)
4.8.3.3.2 Limits
4.8.4 Conformance (26)
(26)
Restrictions
Access
4.9 User
(26)
4.9.1 Definition
(26)
4.9.2 Requirement
(27)
4.10 Geo-location
capability
(27)
4.10.1 Applicability
4.10.2 Definition
(27)
(27)
4.10.3 Requirements
5 Testing for compliance with technical requirements (27)
5.1 Conditions for testing (27)
5.1.1 Normal and extreme test conditions (27)
5.1.2 Test sequences and traffic load (27)
5.1.2.1 General test transmission sequences (27)
5.1.2.2 Test transmission sequences for DFS tests (28)
(28)
5.1.3 Test
channels
(29)
5.1.4 Antennas
5.1.4.1 Integrated and dedicated antennas (29)
modes
(29)
operating
5.1.4.2 Transmit
5.1.4.2.1 Operating mode 1 (single antenna) (29)
5.1.4.2.2 Operating mode 2 (multiple antennas, no beamforming) (29)
5.1.4.2.3 Operating mode 3 (multiple antennas, with beamforming) (29)
5.1.5 Presentation of equipment (29)
5.1.5.1 Testing of host connected equipment and plug-in radio devices (29)
5.1.5.1.1 The use of a host or test jig for testing plug-in radio devices (30)
5.1.5.1.2 Testing of combinations (30)
5.2 Interpretation of the measurement results (31)
5.3 Essential radio test suites (31)
(31)
5.3.1 Product
information
(33)
5.3.2 Carrier
frequencies
5.3.2.2.1 Conducted measurement (33)
5.3.2.2.2 Radiated measurement (33)
5.3.3 Occupied Channel Bandwidth (34)
5.3.3.1 Test conditions (34)
5.3.3.2 Test method (34)
5.3.3.2.1 Conducted measurement (34)
5.3.3.2.2 Radiated measurement (35)
5.3.4 RF output power, Transmit Power Control (TPC) and power density (35)
5.3.4.1 Test conditions (35)
5.3.4.2 Test method (35)
5.3.4.2.1 Conducted measurement (35)
5.3.4.2.2 Radiated measurement (45)
5.3.5 Transmitter unwanted emissions outside the 5 GHz RLAN bands (45)
5.3.5.1 Test conditions (45)
5.3.5.2 Test method (46)
5.3.5.2.1 Conducted measurement (46)
5.3.5.2.2 Radiated measurement (48)
5.3.6 Transmitter unwanted emissions within the 5 GHz RLAN bands (48)
5.3.6.1 Test conditions (48)
5.3.6.2 Test method (48)
5.3.6.2.1 Conducted measurement (48)
5.3.6.2.2 Radiated measurement (50)
5.3.7 Receiver spurious emissions (50)
5.3.7.1 Test conditions (50)
5.3.7.2 Test method (50)
5.3.7.2.1 Conducted measurement (50)
5.3.7.2.2 Radiated measurement (52)
5.3.8 Dynamic Frequency Selection (DFS) (52)
5.3.8.1 Test conditions (52)
5.3.8.1.1 General (52)
5.3.8.1.2 Selection of radar test signals (52)
5.3.8.1.3 Test set-ups (53)
5.3.8.2 Test method (54)
5.3.8.2.1 Conducted measurement (54)
5.3.8.2.2 Radiated measurement (61)
5.3.9 Adaptivity (channel access mechanism) (61)
5.3.9.1 Test conditions (61)
5.3.9.2 Test method (61)
5.3.9.2.1 Conducted measurements (61)
5.3.9.2.2 Generic test procedure for measuring channel/frequency usage (63)
5.3.9.2.3 Radiated measurements (64)
Annex A (normative): HS Requirements and conformance Test specifications Table (HS-RTT) (65)
Annex B (normative): Test sites and arrangements for radiated measurements (67)
B.1 Introduction (67)
B.2 Radiation test sites (67)
B.2.1 Open Area Test Site (OATS) (67)
B.2.2 Semi Anechoic Room (68)
B.2.3 Fully Anechoic Room (FAR) (69)
B.2.4 Measurement Distance (70)
B.3 Antennas (71)
B.3.1 Introduction (71)
B.3.2 Measurement antenna (71)
B.3.3 Substitution antenna (71)
B.4 Test fixture (71)
B.4.1 Introduction (71)
版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系QQ:729038198，我们将在24小时内删除。
发表评论